Next: Results Up: Testing The Law Previous: Introduction

Experimental procedure

The experimental procedure described in the lab manual [2, pp. 13-17] was followed exactly. We found that the following changes were necessary to make the circuit work:

xxx xxxxx xxxxx xxx xxxx xxxx xxxxx xxxxx xxxx xxxxx xxxx xxxxxxxxx xxx xxxxx xxxxx xxx xxxx xxxx xxxxx xxxxx xxxx xxxxx xxxx xxxxxxxxx
xxx xxxxx xxxxx xxx xxxx xxxx xxxxx xxxxx xxxx xxxxx xxxx xxxxxxxxx xxx xxxxx xxxxx xxx xxxx xxxx xxxxx xxxxx xxxx xxxxx xxxx xxxxxxxxx The modified circuit diagram is presented in Figure 2.

Figure 2: The modified circuit diagram was drawn with edgr and saved as a PostScript file.

$\includegraphics[width=0.8\textwidth]{circuit.PS}$
xxx xxxxx xxxxx xxx xxxx xxxx xxxxx xxxxx xxxx xxxxx xxxx xxxxxxxxx xxx xxxxx xxxxx xxx xxxx xxxx xxxxx xxxxx xxxx xxxxx xxxx xxxxxxxxx

**Figure 2:** The modified circuit diagram was drawn with `edgr` and saved as a PostScript file.
$\includegraphics[width=0.8\textwidth]{circuit.PS}$

For info, write to: physics@brocku.ca
Last revised: 2008-01-22